How do I enable/disable my Iptables firewall?

To start IP tables on your RedHat server,
# service iptables start

You can run the following command to stop iptabes:
# service iptables stop

It is also important to save your iptables configuration so that it is loaded again on the next reboot. This can be done by running:

# service iptables save

You can also set the iptables program to start on boot by running:
# chkconfig iptables on

  • Email, SSL
  • 22 Users Found This Useful
Was this answer helpful?

Related Articles

Howto Install B.F.D Brute Force Detection

wget http://oratoronline.com/how2/BFD/bfd-current.tar.gz tar -xvzf bfd-current.tar.gz cd bfd-0.7...

Hardware Firewall configuration

A Hardware Firewall is a network device that is connected upstream from a server. The Firewall...

Configure APF Firewall

A firewall is a very good idea for a server. Though many people think that a firewall is...

How to install APF (Advanced Policy Firewall)

What is APF (Advanced Policy Firewall)? APF FirewallAPF is a policy based iptables firewall...

Ranges to allow through server firewall

Frontend (public) network:Ports to allow:ICMP – ping (for support troubleshooting)All...

Powered by WHMCompleteSolution